Tags

This is the 4.9.200 stable release

This is the 4.4.200 stable release

This is the 5.3.9 stable release

This is the 4.19.82 stable release

This is the 4.14.152 stable release

This is the 4.9.199 stable release

This is the 4.4.199 stable release

wireless-drivers-next patches for 5.5

First set of patches for 5.5. The most active driver here clearly is
rtw88, lots of patches for it. More quiet on other drivers, smaller
fixes and cleanups all over.

This pull request also has a trivial conflict, the report and example
resolution here:

https://lkml.kernel.org/r/20191031111242.50ab1eca@canb.auug.org.au

Major changes:

rtw88

* add deep power save support

* add mac80211 software tx queue (wake_tx_queue) support

* enable hardware rate control

* add TX-AMSDU support

* add NL80211_EXT_FEATURE_CAN_REPLACE_PTK0 support

* add power tracking support

* add 802.11ac beamformee support

* add set_bitrate_mask support

* add phy_info debugfs to show Tx/Rx physical status

* add RFE type 3 support for 8822b

ath10k

* add support for hardware rfkill on devices where firmware supports it

rtl8xxxu

* add bluetooth co-existence support for single antenna

iwlwifi

* Revamp the debugging infrastructure

i.MX defconfig update for 5.5:
 - Enable i.MX7ULP watchdog, DA9052 touch and USB configfs support
   in imx_v6_v7_defconfig.
 - Enable newly added S32V234 SoC and its UART driver support in arm64
   defconfig.
 - Built i.MX8QXP SCU key driver as module in arm64 defconfig.
 - Change AT803X Ethernet PHY driver from module to built-in, so that
   we can boot i.MX8MM EVK board with rootfs on NFS.

LX2160A TMU support for 5.5:
 - Add TMU (Thermal Monitoring Unit) device node to enable thermal
   support on LX2160A SoC.

i.MX arm64 device tree changes for 5.5:
 - Add the initial support for a new arm64 family SoC from NXP:
   S32V234 ("Treerunner") vision microprocessors which are targeted for
   high-performance, computationally intensive vision and sensor fusion
   applications that require automotive safety levels.
 - New board support: i.MX8MN LPDDR4 EVK, i.MX8QXP Colibri and
   S32V234 EVB.
 - A series of patch from Andrey Smirnov to improve zii-ultra support by
   fixing regulator and adding accelerometer, switch watchdog.
 - Add system counter device and enable cpuidle support for i.MX8MN.
 - Move usdhc clocks assignment from SoC to board level DTS for
   i.MX8 based boards.
 - Add PCA6416 on I2C3 bus for imx8mm-evk, and enable SCU key for
   imx8qxp-mek board.
 - Enable GPU passive throttling on i.MX8MQ SoC, and add DDR PMU device
   for i.MX8MN.
 - A series from Fabio Estevam to fix DTC W=1 warnings for LS1028A device.
 - Update the clock providers for the Mali DP500 and '#clock-cells' of
   DPCLK node for LS1028A SoC.
 - Misc small updates on various boards.

i.MX device tree changes for 5.5:
 - New board support: Netronix E60K02 and Kobo Clara HD, Kontron N6311
   and N6411, OPOS6UL and OPOS6ULDev.
 - Correct speed grading fuse settings and add opp-suspend property for
   i.MX7D device tree.
 - Move usdhc clocks assignment from SoC to board level DTS for imx7ulp,
   and use APLL_PFD1 as usdhc's clock source on imx7ulp-evk board.
 - Add missing cooling device properties for CPUs for i.MX6/7 SoCs.
 - Add sensor GPIO regulator and assign power supplies for magnetometer
   for imx6ul-14x14-evk board.
 - Replace "simple-bus" with "simple-mfd" for ANATOP device for i.MX6/7
   SoCs.
 - Fix DTC W=1 warnings by not using simple-audio-card,dai-link on
   imx6qdl-gw551x and imx6q-gw54xx board.
 - Move to use DRM bindings for the Seiko 43WVF1G panel on imx53-qsb.
 - A series from Frieder Schrempf to support more i.MX6UL/ULL-based SoMs
   and boards from Kontron Electronics GmbH.
 - A few patches from Michal Vokáč to enable more devices support on
   imx6dl-yapp4 board.
 - A patch series from Philippe Schenker to improve i.MX6/7 Apalis and
   Colibri board support.
 - A patch series from Sébastien Szymanski to update i.MX6 APF6/APF6Dev
   device tree with more devices added and adopting DRM bindings for
   display.
 - Random improvements, clean-up and device additions on various boards.

i.MX dt-bindings update for 5.5:
 - Update fsl.yaml to include DT compatibles for following devices:
   Kobo Clara HD, i.MX8MN LPDDR4 EVK, S32V234-EVB, Kontron i.MX6UL/ULL
   boards, Toradex apalis/colibri boards, Variscite and Armadeus i.MX6
   boards.

i.MX SoC update for 5.5:
 - Add arm64 Kconfig option for the NXP S32 platform.
 - Drop imx_anatop_usb_chrg_detect_disable() function which becomes
   unneeded, since all the necessary charger setup is done by the USB
   PHY driver now.
 - Add serial number support for i.MX6/7 SoCs by reading 64-bit SoC
   unique ID from OCOTP block.
 - Replace i.MX machine specific coherency exit implementation using
   the generic v7_exit_coherency_flush() function.

i.MX drivers update for 5.5:
 - Skip return check for those SCU firmware APIs that are defined as
   void function in firmware.
 - Use established serial_number attribute instead of custom one to show
   SoC's unique ID for i.MX8 SoC drivers.
 - Read i.MX8MQ SOC revision from TF-A which parses ROM and exposes the
   value through a SMC call. This improves the situation that SOC
   revision reports 'unknown' on some older revisions.
 - Add a check and warn on unexpected SCU RX to avoid potential stack
   corruption in imx-scu driver.
 - Fix a sparse warning in imx-scu-irq driver by adding missing header.
 - Remove an unneeded call to devm_of_platform_populate() from imx-dsp
   driver.

i.MX clock changes for 5.5:
 - Make 1443X/1416X PLL clock structure common for reusing among i.MX8
   SoCs.
 - A couple of imx7ulp clock multiplexer option corrections.
 - Drop IMX7ULP_CLK_MIPI_PLL clock, as it's a MIPI DSI local clock and
   shouldn't be used externally.
 - Add VIDEO2_PLL clock for imx8mq which is needed by DCSS when high
   resolutions are used.
 - Add missing gate clock for pll1/2 fixed dividers on i.MX8 SoCs.
 - Register SYS_PLL1 and SYS_PLL2 as fixed clock rather than pll14xx
   type of clock.
 - Use imx_obtain_fixed_clk_hw() to simplify i.MX6/7/8 clock driver code
   a little bit.
 - One cosmetic change on clk-pll14xx code to make variables static.

Linux 5.4-rc6

This is the 3.16.76 stable release

next-20191031